Alliance Laundry Systems Washer-Extractors UCG

Disconnect the electrical power to washer-extractor to reduce the risk of electrical shock, serious injury, or death.

Electrical Connections Inspection

Inspect the electrical connections for looseness after disconnecting power.

Is the insulation intact on all external wires and all connections secure?

If bare wire is evident, call a service technician and describe the issue.

Inlet Hose Filter Screens Cleaning

Turn water off and allow valve and water line to cool, if necessary.

Unscrew inlet hose from the faucet and remove filter screen.

Disconnect power to the machine at its source

Remove the front panel(s) and rear access panels

Inspect all hose, drain, and overflow connections/clamps for leaks

Inspect all hoses for visible signs of deterioration

Inspect the belt for unusual wear, frayed edges, and improper belt tension

Is the belt properly seated on pulleys?

Inspect the door interlock before starting operation

Is the door lock and interlock functioning properly?

Disconnect power and call a service technician if the door lock and interlock are not functioning properly.

Check the machine for leaks by starting an unloaded cycle to fill the machine.

Verify the following during the leak check

Inspect the water inlet valve hose connections on the back of the machine for leaks.

Inspect the chemical connections for leaks or cracks for machines equipped with an automatic chemical supply system.

Inspect the steam hose connections for leaks, if applicable.

Remove dirt and grease with detergent and water.

Thoroughly rinse and dry after washing.

Ensure no contact with dissimilar metals to prevent galvanic corrosion.

Wipe clean any salty or acidic residues.

Rub in the direction of the polish lines or 'grain' of the stainless steel.