Alliance Laundry Systems Washer-Extractors HCD

Remove dirt and grease with detergent and water.

Thoroughly rinse and dry after washing.

Avoid contact with dissimilar metals.

Wipe clean any salty or acidic residues.

Rub in the direction of the polish lines or grain.

Disconnect power to the machine at its source before performing maintenance procedures.

Inspect all hose, drain, and overflow connections/clamps for leaks and visible signs of deterioration. Replace as necessary.

Inspect the belt for unusual wear, frayed edges, and improper belt tension. Replace or adjust as necessary.

Ensure belts are not twisted and are properly seated on pulleys.

Verify the belt is centered on the basket pulley within 0.04 inches [1 mm].

Inspect the door interlock before starting operation

Is the door lock and interlock functioning properly?

Check the machine for leaks by starting an unloaded cycle to fill the machine.

Verify the following during the leak check

Inspect the water inlet valve hose connections on the back of the machine for leaks.

Inspect the chemical connections for leaks or cracks for machines equipped with an automatic chemical supply system.

Inspect the steam hose connections for leaks, if applicable.

Ensure all panels and guards are properly installed.

Disconnect the electrical power to washer-extractor to reduce the risk of electrical shock, serious injury, or death.

Electrical Connections Inspection

Inspect the electrical connections for looseness.

Verify that insulation is intact on all external wires and that all connections are secure.

If bare wire is evident, call a service technician and describe the issue.

Inlet Hose Filter Screens Cleaning

Turn water off and allow valve and water line to cool, if necessary.

Unscrew inlet hose from the faucet and remove filter screen.