SureShot Dispensing Systems Refrigerated Liquid Dispenser AC210­-SS FlexoShot

Catch Tray Removal and Initial Rinse

Remove the catch tray by lifting it up and off. Does the dispenser have a catch tray?

Rinse the tray with lukewarm potable water

Ensure the water temperature is at least 140ºF or 60ºC

Add a good quality general cleaner to the hot wash water at the recommended concentration

Wash thoroughly using a bottle brush to reach all corners and crevices

If a dishwasher is available, was the tray washed on the pot cycle?

Remove the product case from the refrigerated product compartment of the dispenser

Wash with hot, soapy water or an approved sanitary cleaning product

Rinse with hot, clear water to remove soap residue

Is the case cleaned each time the valve is cleaned or more frequently if required?

Cleaning the Exterior of the Dispenser

Use a soft, dry cloth to wipe down the exterior surfaces of the dispenser.

Wash the stainless steel exterior surfaces with warm, soapy water.

If the water is hard, did you wipe the dispenser dry with a soft cloth to prevent water spotting?

Use stainless steel polish by spraying it on a cloth before wiping down the exterior surfaces.

Wipe the front of the dispenser clean.

Check for ice build-up in the refrigerated product compartment

Remove and discard any accumulated ice

Wipe the interior with a soft cloth

Prepare a container of warm, soapy water

Ensure not to dislodge the cable during cleaning

Turn the power to the dispenser OFF

Drain product tanks and remove empty tanks

Open the door to the refrigerated product compartment

Remove the catch tray (if applicable) by lifting it up and off

Remove the 4 pan-head screws and carefully remove the front splash panel/valve cover