SureShot Dispensing Systems Refrigerated Liquid Dispenser AC320­-FP IntelliShot

Is there any ice build-up in the dispenser?

Gently remove ice build-up, if any ice forms.

Is the ice build-up removed during a defrost cycle?

Unplug the dispenser and leave the door open for about 15 minutes to allow the ice to soften.

Is a temperature adjustment required?

If temperature adjustment is required, describe the issue.

Remove the product case from the refrigerated product compartment of the dispenser

Wash with hot, soapy water or an approved sanitary cleaning product

Rinse with hot, clear water to remove soap residue

Was the product case cleaned each time the valve was cleaned or more frequently if required?

Remove the tank from the dispenser when the product has run out.

Remove and discard the product delivery tube from the tank.

Rinse the tank and cover with lukewarm potable water.

Ensure water temperature is at least 140º F or 60º C.

Add general cleaner to the hot wash water as recommended by the detergent supplier.

Wash thoroughly using a bottle brush to reach all corners and crevices.

Prepare a container of warm, soapy water before disassembling the valve.

Ensure not to dislodge the cable during cleaning.

Turn the power to the dispenser OFF.

Open the dispenser door to the refrigerated product compartment.

Remove the product tanks by following the instructions on page 12.

Remove the catch tray (if applicable) by lifting it up and off.

Remove the 4 pan-head screws securing the front splash panel and carefully remove the panel.

Cleaning the Exterior of the Dispenser

Use a soft, dry cloth to wipe down the exterior surfaces of the dispenser.

Wash the stainless steel exterior surfaces with warm, soapy water.

If the water is hard, did you wipe the dispenser dry with a soft cloth to prevent water spotting?

Use stainless steel polish by spraying it on a cloth before wiping down the exterior surfaces.

Wipe the front of the dispenser clean.