Sullair Compressor PDR32L

Warning: This procedure requires trained personnel with PPE!

Is the coupling aligned properly?

If coupling is not aligned properly, refer to the maintenance section of the manual

Upload a photo of the coupling alignment

Did the coupling pass the alignment check?

Sign off on the coupling alignment check

Place a bright light inside the element to inspect for damage or leak holes. Concentrated light will shine through the element and disclose any holes.

Inspect all gaskets and gasket contact surfaces of the housing. Should faulty gaskets be evident, correct the condition immediately.

If the clean element is to be stored for later use, it must be stored in a clean container.

After the element has been installed, inspect and tighten, if necessary, all air inlet connections prior to resuming operation.

Sign off on the air filter element inspection

Replace your separator element when the separator maintenance indicator shows a red signal. The separator element must be replaced. Do not clean the dirty element.

When replacing the primary separator, check the secondary separator for any holes or cracks that would allow fluid to flow through and replace if necessary. Use secondary separator replacement kit number 13631. Follow the procedure explained below for separator replacement.

1. Remove bolts holding separator to the sump

3. Scrape old gasket from sump cover.

5. Place new separator on the sump cover.

Replace your separator element when the separator maintenance indicator shows a red signal. The separator element must be replaced. Do not clean the dirty element.

When the separator maintenance shows a red signal, separator replacement is necessary. Use primary separator replacement kit number 11173. Follow the procedure explained below for separator replacement.

1. Remove all piping connected to the sump cover to allow removal (return line, service line, etc.).

2. Remove cover bolts and lift cover from sump.

4. Scrape old gasket material from cover and flange on sump.

7. Inspect secondary separator element and replace if necessary (see Secondary Separator Replacement).

Disassemble the filter by removing four (4) capscrews and separate the filter head and element (as an assembly) from the housing.

Remove the hex nut (located inside the element) from the valve stem.

Pull the element, spring, spring seat and spring retainer from the valve stem.

Remove the inner seals of the element and the filter head seal and discard.

Clean all parts of the filter thoroughly including the housing.

Lubricate the new inner seals and install in the ends of the clean element.

Place the filter element, spring seat, spring and spring retainer over the valve stem and secure with the hex nut.