Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Sullair Rotary Vacuum System VS16 50HP: Open

Create an account to install this asset package.

Maintenance Plans for Sullair Rotary Vacuum System Model VS16 50HP: Open

Integrate maintenance plans directly into your work orders in MaintainX.

Initial 50 Hours Vacuum System Maintenance

Maintenance after initial 50 hours of operation

Clean the return line strainer(s)

Clean the return line orifice(s) if so equipped

Clean the vacuum unit gear housing, bearing and shaft seal orifices

Warning: Care must be taken not to damage the shaft

Clean the fluid pump suction strainer

Sign off on the maintenance completion

Run this procedure

1 Yearly Separator Element Replacement - 30-40HP/ 22-30KW

Warning: This procedure requires trained personnel with PPE!

Relieve all pressure from the sump tank

Disconnect all piping connected to the sump cover

Loosen and remove the twelve (12) hex head capscrews from the cover plate

Lift the cover plate from the sump

Remove the element(s)

Inspect the receiver/sump tank for rust, dirt, etc.

Scrape the old gasket material from the cover and the flange on the sump

Reinsert the separator element(s) into the sum

Run this procedure

Filter Element Replacement

6.7 PARTS REPLACEMENT AND ADJUSTMENT PROCEDURES

FILTER ELEMENT REPLACEMENT

Using a strap wrench, remove the old element and gasket.

Clean the gasket seating surface.

Apply a light film of fluid to the new gasket.

Hand tighten the new element until the new gasket is seated in the gasket groove.

Continue tightening element by hand an additional 1/2 to 3/4 turn.

Restart the machine and check for leaks.

Sign off on the filter element replacement

Run this procedure

Control System Adjustment

Refer to Figure 6-4. Prior to adjusting the Control System, it is necessary to determine the desired operating vacuum range.

Enter the desired operating vacuum in in-Hg.

Is the vacuum regulator adjusted for the vacuum at which modulation of gas delivery should begin?

The regulator is adjusted by loosening the jam nut on the end of the cone shaped spring cover of the vacuum regulator.

Is the jam nut loose?

Turn the adjusting screw

Enter the vacuum at which the regulator allows atmospheric pressure to flow into the control chamber of the Sullicon Control in in-Hg.

Did the Sullicon Control lever start to move?

If the vacuum unit is equipped with the optional dual control, the vacuum switch contacts should open at 23 in-Hg. (584mm) and reclose at 20 in-Hg. (508mm).

Run this procedure

4000 Hourly / 6 Monthly Fluid Filter Maintenance

Fluid Filter Maintenance

Filter maintenance gauge indicates replacement

Enter the machine's hour meter reading

Enter the date of the last fluid filter replacement

Fluid change performed

Upload a photo of the new fluid filter

Sign off on the fluid filter maintenance

Run this procedure