Otto Boge Scroll Compressor EO 6TR

10 bar compressor: After 5,000 operating hours but after two years at the latest.

8 bar compressor: After 10,000 operating hours but after four years at the latest.

Have the following maintenance work on the scroll compressors carried out exclusively by BOGE Service personnel.

The following work must be carried out:

– Replace "Tip Seal" sealant on scroll compressor

– Service / lubricate scroll compressor bearing

– Clean cooling fins on scroll compressor.

Warning: Risk of injury due to sharp edges, hot surfaces and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Switch off the compressor using the OFF button.

Open the mains disconnecting device and secure it to prevent it being switched on again.

Allow all hot compressor components to cool to 50°C.

Remove all the safety claddings necessary for maintenance work.

Open the respective housing panel. Secondary cooler: remove the housing panel above the operating elements / control.

ATTENTION: Danger of property damage! Do not use sharp objects to clean the cooler. They may damage the cooler.

Clean off the accumulated soiling with a fibre brush.

Primary cooler: suck out any dirt from the system in the same direction as the normal flow of cooling air. Do not under any circumstances blow dirt into the system using compressed air.

WARNING: Risk of injury due to sharp edges, hot surfaces, overpressure and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Switch off the compressor using the OFF button.

Open the mains disconnecting device and secure it to prevent it being switched on again.

Allow all hot compressor components to cool to 50°C.

Remove the right side panel of the housing and the isolating protective equipment.

Loosen the screws on the scroll compressor fan covers and remove the covers.

Check the fans and clean if necessary.

10 bar compressor: After 5,000 operating hours but after two years at the latest.

8 bar compressor: After 10,000 operating hours but after four years at the latest.

Have the following maintenance work on the scroll compressors carried out exclusively by BOGE Service personnel.

The following work must be carried out:

– Replace "Tip Seal" sealant on scroll compressor

– Service / lubricate scroll compressor bearing

– Clean cooling fins on scroll compressor.

WARNING: Risk of injury due to sharp edges, hot surfaces, overpressure and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Switch off the compressor using the OFF button.

Open the mains disconnecting device and secure it to prevent it being switched on again.

Allow all hot compressor components to cool to 50°C.

Remove the service side cladding.

Loosen all four motor fastening screws (2).

Turn the belt tensioning screw (1) anti-clockwise.