Otto Boge Scroll Compressor EO 6

Warning: Risk of injury due to sharp edges, hot surfaces, overpressure and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Is the suction filter cartridge damaged?

Has the suction filter cartridge been cleaned twice?

Enter the operating hours of the compressor

Is the compressor switched off?

Is the mains disconnecting device opened and secured?

Enter the temperature of the compressor components

Is the old filter cartridge removed?

WARNING: Risk of injury due to sharp edges and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Prior to the maintenance work: Open the mains disconnecting device and secure against accidental switching on again using a padlock.

Switch off the compressor using the OFF button.

Open the compressor housing at the front.

Remove the filter housing lid (1).

Take out the filter cartridge (2).

ATTENTION: Danger of property damage! Do not clean the filter cartridge in liquids. Do not use hard objects for cleaning as doing so will damage the filter paper. Replace the filter cartridge if it is damaged or has been cleaned twice.

Tap the filter cartridge with your hand to knock out coarse dust.

Blow out fine dust using dry compressed air (max 5 bar) from the inside to outside.

WARNING: Risk of injury due to sharp edges, hot surfaces, overpressure and exposure to dust! This maintenance work should only be carried out by authorised and qualified personnel. Wear PPE.

Switch off the compressor using the OFF button.

Open the mains disconnecting device and secure it to prevent it being switched on again.

Allow all hot compressor components to cool to 50°C.

Remove the right side panel of the housing and the isolating protective equipment.

Loosen the screws on the scroll compressor fan covers and remove the covers.

Check the fans and clean if necessary.

Risk of injury from flying parts caused by overpressure, e.g., burst components bursting or detonating!

Risk of injury due to sudden discharge of hot compressed air!

It is forbidden to operate the compressor without the installed safety devices.

A safety valve prevents inadmissible overpressure.

The specified final compression pressure must not be exceeded.

Observe the statutory regulations applicable in the installation location for operating safety devices against overpressure.

Have the function of the safety valve checked exclusively by BOGE Service personnel.

Interval: After approx. 3000 operating hours but at least once a year.

Warning: This maintenance check requires trained personnel with PPE!

Motor running under normal operating conditions?

If motor is not running under normal conditions, report the issues to the maintenance team and stop the procedure

Choose the type of service done

Motor passed the post-maintenance test?

Sign off on the motor bearing maintenance