Maytag Washer HAV2460*

Disconnect the unit from the power source

Tip unit and remove the drive belt

Disconnect the inlet hoses from the water mixing valve

Remove the access panel from the cabinet rear and disconnect the discharge hose from the pump outlet

Disconnect lower wiring from the cabinet rear and remove pressure switch hose from tub air bell

Disconnect the unit from the power source

Raise the top and open the clothes door

Remove the two screws securing the safety switch assembly to the underside of the top

Place test leads across the terminals at each end of switch

Are the switch contacts open and continuity NOT indicated?

Operate the washer in the agitation cycle with hot water for about two (2) minutes.

Operate the washer in a spin cycle for two (2) minutes.

Place a 3 1/2 pound weight, such as a bag of sand, in the washer basket.

Start the machine in the spin cycle.

Did the basket reach full spin speed with the weight?

Describe any issues observed during the initial spin efficiency test.

Disconnect the unit from the power source

Remove the bearing and seal housing and the tub support

Remove the seal body from the housing cavity

Press the spin bearing out of the cavity from the opposite side of the housing

Install the replacement bearing into the housing cavity

Press against the outer race of the bearing to avoid damage

Check that all parts are in place

Test the washer for proper operation after reassembly

Describe any issues encountered during the replacement

Disconnect the unit from the power source

Remove all wiring from the solenoid(s) being tested

Place the test leads across the terminals of the solenoid being tested and record the meter reading

Does the meter indicate continuity across the terminals?

Enter the resistance reading of the coil in ohms

Is the resistance approximately 860 ohms?