JUNGHEINRICH Industrial Truck EFG 430k

Correct the brake fluid level via the check hole in the brake housing

Correct the transmission oil level or grease filling of the transmission

Lubricate the contact surfaces of the mast

WARNING! A faulty attachment can be hazardous. Check the attachment daily for external signs of damage or defects. Faulty attachments can cause the load to fall. Report any defects immediately to your supervisor. Tag out and decommission a faulty lift truck. Only return the truck to service when you have identified and rectified the fault. No welding work may be carried out without a permit from the manufacturer.

Check for external signs of damage or defects

Is the lift truck decommissioned if faulty?

Is the truck returned to service only after rectifying the fault?

Is there a permit for any welding work?

Sign off on the daily attachment inspection

Hydraulic system breather filter replaced?

Sign off on the maintenance completion

Lubricate the contact surfaces of the mast.

Correct the hydraulic-oil level.

Correct the fill level of the windscreen washer reservoir.

WARNING! Using different tyres can cause accidents. The quality of the tyres affects the operational stability and performance of the truck. The diameter of the wheels must differ by no more than 15 mm. Always replace tyres in pairs, i.e. left and right at the same time. After replacing the tyres, check that the wheel bolts/nuts are secure after 10 operating hours. Always use tyres of the same make, model and profile.

Requirements – Truck prepared for maintenance and repair work (see page 314). Tools and Material Required – Torque wrench

Are the tyres of the same make, model and profile?

Enter the diameter difference between the wheels

Are the tyres replaced in pairs?

Enter the number of operating hours after tyre replacement

Are the wheel bolts/nuts secure?

Enter the torque of the wheel bolts/nuts

Is the mounting of wheels checked?