JUNGHEINRICH Industrial Truck EFG 430

Correct the brake fluid level via the check hole in the brake housing

Correct the transmission oil level or grease filling of the transmission

Lubricate the contact surfaces of the mast

WARNING! A faulty attachment can be hazardous

Check the attachment daily for external signs of damage or defects. Faulty attachments can cause the load to fall.

Check for any visible damage or defects on the attachment

Reported any defects immediately to your supervisor?

Tagged out and decommissioned a faulty lift truck?

Only returned the truck to service when you have identified and rectified the fault?

No welding work may be carried out without a permit from the manufacturer.

Sign off on the daily attachment inspection

Hydraulic system breather filter replaced?

Sign off on the maintenance completion

Lubricate the contact surfaces of the mast

Correct the hydraulic-oil level

Correct the fill level of the windscreen washer reservoir

Correct the battery-acid level using demineralised water

Test emergency disconnect switch and check for damage

WARNING! Using different tyres can cause accidents. The quality of the tyres affects the operational stability and performance of the truck. The diameter of the wheels must differ by no more than 15 mm. Always replace tyres in pairs, i.e. left and right at the same time. After replacing the tyres, check that the wheel bolts/nuts are secure after 10 operating hours. Always use tyres of the same make, model and profile.

Requirements – Truck prepared for maintenance and repair work (see page 314). Tools and Material Required – Torque wrench

Torque the wheel bolts/nuts (265) crosswise with a torque wrench – torques: see page 44.

The mounting of wheels is now checked.

When using pneumatic tyres check the air pressure, for the air pressure see page 44.

Sign off on the wheel attachment check