JCB Backhoe Loader 4CX-4WS

- Change Engine Oil and Filter (AK and AR Build)

- Change Engine Oil and Filter (RE and RG Build)

- Change Engine Air Cleaner Outer Element

- Change Engine Fuel Filter (AK and AR Build)

- Change Engine Fuel Filter (RE and RG Build)

- Clean Lift Pump Strainer (AK and AR Build Only)

- Drain and Clean Engine Fuel Sedimenter

- Check Fan Belt Tension/Condition

WARNING! An exploding tyre can kill, inflated tyres can explode if overheated. Do not cut or weld the rims. Use a tyre/wheel specialist for all repair work

Is the tyre correctly fitted on the machine or installed in a tyre inflation cage?

Set the regulator no higher than 1.38 bar (20 psi) above the recommended tyre pressure.

Is the air hose fitted with a self-locking air chuck and remote shut-off valve?

Is the air hose correctly connected to the tyre valve?

Is the area clear of other people?

Inflate the tyre to the recommended pressure. Do not over-inflate.

Sign off on the tire maintenance

Drain and Clean Engine Fuel Sedimenter

Sign off on the engine maintenance

On new machines, and whenever a wheel has been removed, check the wheel nut torques every two hours until they stay correct

Every day, before starting work, check that the wheel nuts are tight

The correct torques are shown in the table below: Front - Nm 680 / Ibf ft 500, Rear - Nm 680 / Ibf ft 500

WARNING! If, for whatever reason, a wheel stud is renewed, all the studs for that wheel must be changed as a set, since the remaining studs may have been damaged

Wheel nuts checked and tightened?

Enter the torque of the front wheel nuts

Enter the torque of the rear wheel nuts

Sign off on the wheel nut check

Sign off on the loader maintenance