JCB Backhoe Loader 215

Sign off on the loader maintenance

These instructions are for adding air to a tyre which is already inflated. If the tyre has lost all its air pressure, call in a qualified tyre mechanic. The tyre mechanic should use a tyre inflation cage and the correct equipment to do the job

An exploding tyre can kill, inflated tyres can explode if overheated. Do not cut or weld the rims. Use a tyre/wheel specialist for all repair work

Before you add air to the tyre, make sure it is correctly fitted on the machine or installed in a tyre inflation cage

Use only an air supply system which includes a pressure regulator. Set the regulator no higher than 1.38 bar (20 psi) above the recommended tyre pressure. See Section F, Technical Data for recommended tyres and pressures for your machine

Check the fire extinguisher for damage, security and signs of leaking

Check that the gauge B indicates that the extinguisher is charged

Note: If the needle is in or very near the RED segment at either end of the gauge, the extinguisher must be serviced or replaced

Make sure the safety pin is fitted and secure

The extinguisher should be serviced every 12 months by a suitably qualified person

Sign off on the fire extinguisher service

Sign off on the loader hydraulics maintenance

Check Axle Oil Level (incl. Hubs when applicable)

Change Axle Oil - Limited Slip Differential

Check Steer Axle Movement/Shimming

Grease Steer Axle Pivots and Linkages