JCB Backhoe Loader 4CX-14

Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the attachments to the ground and stop the engine

Clean the machine using water and/or steam. Do not allow mud, debris etc to build upon the machine, pay particular attention to the following areas:

1. Backhoe hoses passing through mainframe

3. Twin ram slew recess in chassis (centremount)

4. Kingpost slide rails (sideshift)

5. Kingpost hose tray and bottom 'shelf' (sideshift)

6. Recess between slew ram and kingpost casting (sideshift)

- Change Engine Oil and Filter (AK and AR Build)

- Change Engine Oil and Filter (RE and RG Build)

- Change Engine Fuel Filter (AK and AR Build)

- Change Engine Fuel Filter (RE and RG Build)

- Clean Lift Pump Strainer (AK and AR Build Only)

- Drain and Clean Engine Fuel Sedimenter

- Check Fan Belt Tension/Condition

- Check Engine Mounting Bolts for Tightness

Sign off on the loader maintenance

Sign off on the loader hydraulics maintenance

Check the fire extinguisher for damage, security and signs of leaking

Check that the gauge B indicates that the extinguisher is charged ie. the needle is in the GREEN segment

Note: If the needle is in or very near the RED segment at either end of the gauge, the extinguisher must be serviced or replaced

Make sure the safety pin is fitted and secure

The extinguisher should be serviced every 12 months by a suitably qualified person

Check the ROPS/FOPS Structure (p.49)

Sign off on the fire extinguisher service