Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

JCB Backhoe Loader 3CX canopy

Create an account to install this asset package.

Maintenance Plans for JCB Backhoe Loader Model 3CX canopy

Integrate maintenance plans directly into your work orders in MaintainX.

1000 Hours / 1 Yeary Loader Engine Maintenance

- Change Engine Oil and Filter (AK and AR Build)

- Change Engine Oil and Filter (RE and RG Build)

- Change Engine Air Cleaner Outer Element

- Change Engine Fuel Filter (AK and AR Build)

- Change Engine Fuel Filter (RE and RG Build)

- Clean Lift Pump Strainer (AK and AR Build Only)

- Check Coolant Quality/Level

- Drain and Clean Engine Fuel Sedimenter

- Check Fan Belt Tension/Condition

Run this procedure

1000 Hours / 1 Yeary Loader Hydraulics Maintenance

Check Hydraulic Oil Level

Change Oil Filter

Check Rams - Chrome Condition

Sign off on the loader hydraulics maintenance

Run this procedure

Loader Cleaning

Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the attachments to the ground and stop the engine

Machine parked and prepared for cleaning?

Clean the machine using water and/or steam. Do not allow mud, debris etc to build upon the machine, pay particular attention to the following areas:

Areas cleaned

Stabiliser cavities cleaned?

Engine and transmission cleaned?

WARNING! Airborne particles of light combustible material such as straw, grass, wood shavings, etc. must not be allowed to accumulate within the engine compartment or in the propshaft guards (when fitted). Please inspect these areas frequently and clean at the beginning of each work shift or more often if required. Before opening the engine cover, ensure that the top is clear of debris

Engine compartment and propshaft guards cleaned?

Avoid using neat detergent - always dilute detergents as per the manufacturer's recommendations, otherwise damage to the paint finish may occur

Run this procedure

1 Yearly Fire Extinguisher Service

Check the fire extinguisher for damage, security and signs of leaking

Check that the gauge B indicates that the extinguisher is charged

Note: If the needle is in or very near the RED segment at either end of the gauge, the extinguisher must be serviced or replaced

Make sure the safety pin is fitted and secure

The extinguisher should be serviced every 12 months by a suitably qualified person

Check the ROPS/FOPS Structure (p.49)

Sign off on the fire extinguisher service

Run this procedure

3 Yearly Seat Belt Maintenance

WARNING! When a seat belt is fitted to your machine replace it with a new one if it is damaged, if the fabric is worn, or if the machine has been in an accident. Fit a new seat belt every three years

Inspect the seat belt for signs of fraying and stretching

Check that the stitching is not loose or damaged. Check that the buckle assembly is undamaged and works correctly

Check that the belt mounting bolts are undamaged, correctly fitted and tightened

Sign off on the seat belt maintenance

Run this procedure