Continental Tumble Dryer NA120N

Inform the fire department about the upcoming test if the auxiliary output is connected to notify them.

Disconnect the auxiliary output if it is connected to activate a building sprinkler system.

Verify the connection to the auxiliary output through the H-4 header connection inside the fire suppression control box.

Check the relay rating and ensure it is within 5 Amp, 250VAC max.

Reconnect the auxiliary output if it was disconnected prior to the test.

Inform the fire department that the test is complete if they were notified before the test.

Check for visible signs of deterioration on hoses

Is there any visible sign of deterioration on the hoses?

Replacement of Deteriorated Hoses

Replace any hose showing signs of deterioration

Verify that all hoses are in good condition after maintenance

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect all ground wires removed during servicing to ensure proper grounding.

Remove all lint from lint compartments and lint screen.

Ensure no open flames are present in the inspection area

Use non-corrosive leak detection fluid

Check all pipe connections for gas leaks

Was the inspection completed without any incidents?

Disconnect electrical power from tumble dryer

Close gas shut-off valve to tumble dryer

Verify that the supply inlet pressure is equipped with a pressure regulator

Attach manometer to the correct location based on gas valve type