Baldor Reliance Electric Motor EJMM3615T-G

Storage — Non-Regreaseable Motors

Rotate the motor shaft 15 times

Rotate ball and roller bearing motor shafts manually

Grease ball and roller bearing motor shafts

Check for moderate dirt and corrosion

Determine if roller bearings are present

Section 3 — Maintenance general principles

Record the current oil level in the sight gauge

Is the oil level at the midpoint of the sight gauge?

Storage — Ball and Roller Bearing Motor Shafts

Rotate motor shafts manually every 3 months

Grease motor shafts every 6 months according to the Maintenance section of the manual

Storage — All Other Motor Types, Before Storage

Remove the grease drain plug on the bottom of each bracket prior to lubricating the motor

Grease the motor with regreaseable bearing as instructed in Section 3 of the manual

Replace the grease drain plug after greasing

Rotate the motor shaft a minimum of 15 times after greasing

Storage — All Other Motor Types, Periodic

Section 3 — Lubrication Procedure

Ensure lubrication is done with the motor stationary and warm

Locate the grease inlet, clean the area, and replace the pipe plug with a grease fitting if necessary

Remove relief plug and clean around it

Is there severe caking at the plug?

Run the motor until the bearing housing is warm if severe caking is present

Locate the motor nameplate and find the recommended lubricant type and volume

Add the recommended volume of lubricant using a hand-operated grease gun

Run the motor for 2 hours with the relief plug removed