Baldor Reliance Electric Motor JML3608T

Section 3 — Lubrication Procedure

Ensure lubrication is done with the motor stationary and warm

Prepare the motor for lubrication

Is grease caked around the plug?

If severe caking appears, run the motor until the bearing housing is warm

Locate the motor nameplate and find the recommended lubricant type and volume

Record the lubricant type and volume from the nameplate

Add the recommended volume of lubricant using a hand operated grease gun

Section 3 — Lubrication Procedure

Ensure lubrication is done with the motor running, stay clear of rotating parts and electrical circuits

Avoid over-lubricating the motor

Relubricate with the shaft stationary and a warm motor is recommended

Locate the grease inlet, clean the area and replace the pipe plug with a grease fitting, if the motor is not equipped with grease fittings

Is grease caked around the plug?

Clean with a wooden stick or suitable tool if grease is caked

Is there severe caking at the plug?

Section 3 — Maintenance general principles

Record the current oil level in the sight gauge

Is the oil level at the midpoint of the sight gauge?

Ensure the motor is not in operation

Check if sleeve bearing motors are drained of oil prior to shipment

Refill oil reservoirs to the indicated level with the specified lubricant

Section 3 — Lubrication Procedure

Ensure lubrication is done with motor running, stay clear of rotating parts and electrical circuits

Ensure not to over-lubricate motor to prevent premature bearing failure

Relubricate with the shaft stationary and a warm motor

Locate the grease inlet, clean the area and replace the pipe plug with a grease fitting if necessary

Is grease caked around the plug?

Clean caked grease with a wooden stick or suitable tool if present

Is there severe caking at the plug?