American Panel Shock Freezer AP20BC(F)200-2

Defrost the unit daily or as needed

Wipe clean the interior of the unit using a solution of mild soap and water

Wipe clean the exterior of the unit using a solution of mild soap and water

Engage the sanitation cycle (if equipped)

Disconnect the unit from the main electrical power

Remove the screws on the right-hand side of the evaporator door

Gently push the lamp from the bottom side until enough of it is to grab

Extract the lamp from the top and disconnect the wire harness

Close and secure the evaporator door

Inspect components for proper operation and seal

Use vacuum and brush to clean the condenser coil

Was the maintenance performed by a service technician or trained personnel?

Ensure unit is properly installed

Verify electrical service according to manufacturer label

Verify proper drain pan installation or hard plumbed

Inspect drain lines for integrity and proper flow

Check door hinges and gasket for proper operation and seal

Clean door gasket with mild soapy warm water

Run the defrost cycle to ensure the coil is free of ice.

Disconnect and lock the main power switch.

Remove screws securing the evaporator door to the vertical frame.

Swing the evaporator door open.

Use a vacuum cleaner or soft non-metallic bristle brush to remove surface fibers and dirt in the direction of the fins.

Spray the coil finned area and return bends with recommended coil cleaner using a pump-up sprayer or conventional spray bottle.