Toyota Skid-Steer Loader 30-5SDK11

1. Operation and installed state - Inspect and correct and replace as required.

Operator guard and side guard 2. Installed portion looseness - Tighten

3 Deformation, crack, damage - Inspect and correct and replace as required.

4. Operation and installed state - Inspect and correct and replace as required.

5. Operation and installed state - Inspect and correct and replace as required.

During hot weather, the following areas are of concern:

1. As water scale and rust easily take place in cooling system (especially in radiator) in hot season, remove water scale and rust with water or cleaning agent and always try to circulate clean water in the cooling system.

2. Clean radiator fins with compressed air to avoid clogging, resulting in overheating. Inspect the radiator for water leaks.

3. Inspect the fan belt for slack. If it is slack, adjust it to the prescribed tension.

4. When the engine is overheated and coolant boils, do not stop the engine immediately, but let it rotate at an idle speed for a while. After the water temperature drops, stop the engine. Also, open the engine hood to expedite cooling.;

Warning: This procedure requires trained personnel with PPE!

Enter the current hour meter reading of the steer loader

Enter the date of the next scheduled replacement

Sign off on the components replacement

Previously detected malfunctions - Correct

Exterior - Vehicle posture, oil leakage, water leakage, loose parts exterior damage

Wheels - Tire pressure, wear or damage, rims; hub nuts

Lamps - Lamp condition damaged lamps

Hydraulic oil - Oil level, contamination, consistency

Radiator- Coolant level, LLC or antifreeze requirement

Engine - Oil level, contamination consistency, noise exhaust

Levers - Looseness; functioning

- Injection timing - Measure and correct and adjust as required.

- Glow plug heat coil breakage - Inspect and correct and replace as required.

- Intake heater - Inspect and correct and replace as required.

- Specific gravity - Measure and correct and adjust as required.;