Toyota Skid-Steer Loader 30-5SDK10

Warning: This procedure requires trained personnel with PPE!

Was the machine operating under hard conditions?

If machine was operating under hard conditions, consider a service interval of 170 hours or 1 month.

Sign off on the components replacement

Warning: Set the ignition switch to the OFF position before starting.

Location of fuse box: Left front as seen from the top left of the driver seat.

If fuse is blown, replace it with a spare fuse.

Caution: Use the fuse having the same capacity as that of the installed one.

If the replaced fuse is blown again, ask a Toyota dealer for inspection.

Warning: Ensure the vehicle is in a safe and stable position before starting the procedure.

Temperature is less than 0°C (32°F)?

Inspect the radiator, water pump, piping and block for leaks before adding antifreeze.

Drain cock on the radiator and engine block loosened?

Radiator and cylinder block flushed with clean water?

Warning: Start the engine and warm it up sufficiently.

Check each meter and warning lamp to see there is no abnormality.

Check if the engine is generating abnormal sound or vibration.

Check the exhaust gas color to see it is normal.

Caution: The exhaust gas can cause serious injury if inhaled, If you must start the engine inside building or enclosure, insure sufficient ventilation.

Sign off on the engine inspection

Measure the inflation pressure of the tire

See the service data section for the proper inflation pressure. Do not raise the pressure beyond the proper level.

Check if air is not leaking from the valve

Check the tires for damage and wear

If the tires are damaged, or there is a marked difference in the wearing of tires between the front and rear or between the left and right is perceived, or bent rims are found, ask a Toyota dealer for inspection.

Sign off on the tire inspection