Toyota Forklift 8FBEK18T

Position a container to collect the oil.

Remove the bushing from the cylinder (upper side).

Remove the seals from the piston rod.

Remove the descent braking device.

Remove the parachute valve (descent safety valve).

Reassembly Procedure: The assembly procedure is the reverse of the disassembly procedure.

Remove the mast lifting height switch

Disconnect the overflow hose and high pressure hoses

Remove the fork carriage assembly

Remove the pulley support (chain and hydraulic pipes)

Remove the central lift cylinder support and the bolt set from the bottom of each cylinder

Remove the central lift cylinders

Remove the bolt set from the ends of the rods on each cylinder and remove the end parts of the rods

Remove all the cylinder supports

2) Disconnect the battery connector.

4) Disconnect the electrical wiring.

The assembly procedure is the reverse of the disassembly procedure.

After replacing the card, the vehicle settings must be repeated (see heading CALIBRATIONS).;

Vehicle parked on a level surface and parking brake applied

Two forks removed from the carriage

2 screws replaced with appropriate eyebolts and fixed to the bridge crane

Fork plate removed by sliding upwards with the bridge crane

Upper guide shoes replaced [Point 2]

Remove the hydraulic oil from the tank

Disconnect the power cables and the wiring from the pump motor

Disconnect the piping from the priority valve (4 wheel version)

Disconnect the hoses from the pump

Unscrew the pump motor fixing nuts