ThermoFisher Scientific Centrifuge 75002402

Ensure decontamination level is achieved according to requirements

Rinse the centrifuge and all affected accessories with water

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824)

Ensure no one is at risk during decontamination

Verify that the decontamination agent or method will not damage the equipment

Contact manufacturer if in doubt about decontamination agent

Clean the centrifuge and rotors thoroughly

Decontaminate the centrifuge and rotors

Enter the cost of repairs (if any)

Was the centrifuge maintained by an authorized Thermo Fisher Scientific service technician?

Inspect seals and seal surfaces for signs of wear and damage

Are all seals and seal surfaces free from damage?

Is the rotor lid properly closed?

Were the sample vessels filled and closed correctly?

Confirm aerosol tightness of the rotor and buckets

Press the large seal in the outer groove of the rotor body (top detail)

Press the small seal into the groove of the rotor collar (bottom detail)

Ensure that the rotor lid closes securely

Is the rotor lid damaged or dulled?

Pull the centrifuge to the edge of the table

Pull the clip below the sucking grid

Remove the filter unit completely by pulling it down

Remove the cumulated dust with a soft cloth

Ensure the labeling 'Front' shows to the front of the centrifuge when inserting the filter