ThermoFisher Scientific Centrifuge 75002412

Did you use the supplied grease for lubrication?

Fill the cavities with approx. 10 ml of carbonated mineral water

Close the rotor as explained in the handling instructions

Shake the rotor vigorously using your hands

Did you avoid applying pressure to the lid while shaking?

Inspect the seals and seal surfaces for signs of wear and damage

Are all seals and seal surfaces free from damage?

Is the rotor lid properly closed?

Are the sample vessels filled and closed correctly?

Confirm the rotor is aerosol-tight after inspection and operation checks

Confirm the centrifuge has reached its 13-year lifetime

Rotor, Buckets, and Lids Inspection

Check the lifetime cycles of each rotor

Inspect rotors for damage or wear

Inspect buckets for damage or wear

Inspect lids for damage or wear

Pull the centrifuge to the edge of the table.

Pull the clip below the sucking grid and remove the filter unit completely by pulling it down.

Remove the cumulated dust with a soft cloth.

Ensure the labeling 'Front' is facing the front of the centrifuge when inserting the filter.

Push the filter upwards into the slot until the clip locks in the bottom plate.

Ensure the level of decontamination is achieved according to requirements

Rinse the centrifuge and all affected accessories with water

Allow the centrifuge and accessories to fully drain and dry

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824)

Ensure no one is at risk during decontamination

Verify that the decontamination agent or method will not damage the equipment

Contact the manufacturer of the decontamination agent if in doubt