ThermoFisher Scientific Centrifuge 75002415

Press the large seal in the outer groove of the rotor body (top detail)

Press the small seal into the groove of the rotor collar (bottom detail)

Ensure that the rotor lid closes securely

Is the rotor lid damaged or dulled?

Ensure decontamination level is achieved according to requirements

Rinse the centrifuge and all affected accessories with water

Allow centrifuge and accessories to fully drain and dry

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824)

Ensure no one is put at risk during decontamination

Verify that the decontamination agent or method will not damage the equipment

Contact manufacturer of the decontamination agent if in doubt

Pull the centrifuge to the edge of the table

Pull the clip below the sucking grid

Remove the filter unit completely by pulling it down

Remove the cumulated dust with a soft cloth

Ensure the labeling 'Front' is facing the front of the centrifuge

Push the filter upwards into the slot until the clip locks in the bottom plate

Ensure all parts are ready for cleaning

Clean rotor, buckets, and accessories outside of the centrifugation chamber

Separate rotor, buckets, lids, tubes, and sealing rings for thorough cleaning

Rinse rotor and accessories with warm water and neutral detergent

Use a soft brush without metal bristles to remove stubborn residue

Rinse rotor and accessories with distilled water

Place rotors on a plastic grate with cavities pointing down to drain and dry

Inspect the seals and seal surfaces for signs of wear and damage

Are all seals and seal surfaces free from damage?

Is the rotor lid properly closed?

Are the sample vessels filled and closed correctly?

Confirm the rotor is aerosol-tight after inspection and operation checks