ThermoFisher Scientific Centrifuge 75002420

Ensure decontamination level is achieved according to requirements

Rinse the centrifuge and all affected accessories with water

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824)

Ensure no one is at risk during decontamination

Verify that decontamination methods or agents will not damage the equipment

Observe safety precautions and handling instructions for decontamination agents used

Use the supplied grease for lubrication

Fill the cavities with approx. 10 ml of carbonated mineral water

Close the rotor as per handling instructions

Shake the rotor vigorously using your hands

Check for leaks by observing escaping water or listening for escaping gas

Replace the seals if any leaks are detected and repeat the test

Ensure all parts are ready for cleaning

Separate rotor, buckets, lids, tubes, and sealing rings

Rinse rotor and accessories with warm water and neutral detergent

Use a soft brush without metal bristles to remove stubborn residue

Rinse rotor and accessories with distilled water

Place rotors on a plastic grate with cavities pointing down

Is the level of disinfection achieved according to your requirements?

Rinse the centrifuge and all affected accessories with water.

Allow the centrifuge and accessories to fully drain and dry.

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824).

Ensure no one is put at risk in case of contamination.

Disinfect affected parts immediately if contamination occurs.

Confirm that the disinfection method or agent will not damage the equipment.

Pull the centrifuge to the edge of the table

Pull the clip below the sucking grid

Remove the filter unit completely by pulling it down

Remove the cumulated dust with a soft cloth

Ensure the labeling 'Front' is facing the front of the centrifuge

Push the filter upwards into the slot until the clip locks in the bottom plate