ThermoFisher Scientific Centrifuge 75002417

Is the level of decontamination achieved according to your requirements?

Rinse the centrifuge and all affected accessories with water.

Allow the centrifuge and accessories to fully drain and dry.

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824).

Ensure no one is at risk of exposure to radiation from contaminated parts.

Decontaminate affected parts immediately if contamination is detected.

Verify that the decontamination method or agent will not damage the equipment.

Press the large seal in the outer groove of the rotor body (top detail)

Press the small seal into the groove of the rotor collar (bottom detail)

Ensure that the rotor lid closes securely when loading the rotor

Check if the rotor lid is damaged or dulled

Pull the centrifuge to the edge of the table

Pull the clip below the sucking grid

Remove the filter unit completely by pulling it down

Remove the cumulated dust with a soft cloth

Ensure the labeling 'Front' is facing the front of the centrifuge

Push the filter upwards into the slot until the clip locks in the bottom plate

Ensure all parts are ready for cleaning

Separate rotor, buckets, lids, tubes and sealing rings

Rinse rotor and all accessories with warm water and neutral detergent

Use a soft brush to remove stubborn residue

Rinse rotor and all accessories with distilled water

Place rotors on a plastic grate with cavities pointing down

Use the supplied grease for lubrication

Fill the cavities with approx. 10 ml of carbonated mineral water

Close the rotor as per handling instructions

Shake the rotor vigorously by hand without applying pressure to the lid

Check for leaks by observing escaping water or hearing escaping gas

Replace the seals if any leaks are detected and repeat the test