ThermoFisher Scientific Centrifuge 75002416

Press the large seal in the outer groove of the rotor body (top detail)

Press the small seal into the groove of the rotor collar (bottom detail)

Ensure that the rotor lid closes securely when loading the rotor

Check if the rotor lid is damaged or dulled

Clean the centrifuge and rotors thoroughly

Decontaminate the centrifuge and rotors

Enter the cost of repairs if applicable

Was the centrifuge maintained by an authorized Thermo Fisher Scientific service technician?

Inspect the seals and seal surfaces for signs of wear and damage

Are all seals and seal surfaces free from damage?

Is the rotor lid properly closed?

Were the sample vessels filled and closed correctly?

Confirm the rotor is aerosol-tight after inspection and operation checks

Ensure all parts are ready for cleaning

Clean rotor, buckets, and accessories outside of the centrifugation chamber

Separate rotor, buckets, lids, tubes, and sealing rings for thorough cleaning

Rinse rotor and accessories with warm water and neutral detergent

Use a soft brush without metal bristles to remove stubborn residue

Rinse rotor and accessories with distilled water

Place rotors on a plastic grate with cavities pointing down to drain and dry

Ensure decontamination level is achieved according to requirements

Rinse the centrifuge and all affected accessories with water

Treat the entire surface of aluminum parts including the cavities with corrosion protection oil (70009824)

Ensure no one is at risk during decontamination

Verify that the decontamination agent or method will not damage the equipment

Contact manufacturer if in doubt about decontamination agent