ThermoFisher Scientific Centrifuge 75002414

Clean the centrifuge and rotors thoroughly

Decontaminate the centrifuge and rotors

Enter the cost of repairs (if any)

Was the centrifuge maintained by an authorized Thermo Fisher Scientific service technician?

Ensure all parts are ready for cleaning

Clean rotor, buckets, and accessories outside of the centrifugation chamber

Separate rotor, buckets, lids, tubes, and sealing rings for thorough cleaning

Rinse rotor and accessories with warm water and neutral detergent

Use a soft brush without metal bristles to remove stubborn residue

Rinse rotor and accessories with distilled water

Place rotors on a plastic grate with cavities pointing down to drain and dry

Inspect the rotor and bucket seals for signs of wear and damage

Are all seals and seal surfaces free from damage?

Is the rotor lid properly closed?

Were the sample vessels filled and closed correctly?

Confirm aerosol tightness of the rotor and buckets

Did you use the supplied grease for lubrication?

Fill the cavities with approx. 10 ml of carbonated mineral water

Close the rotor as explained in the handling instructions

Shake the rotor vigorously using your hands

Did you avoid applying pressure to the lid while shaking?

Pull the centrifuge to the edge of the table

Pull the clip below the sucking grid

Remove the filter unit completely by pulling it down

Remove the cumulated dust with a soft cloth

Ensure the labeling 'Front' is facing the front of the centrifuge

Push the filter upwards into the slot until the clip locks in the bottom plate