New London Engineering Conveyor 420

Enter the air pressure of the drives tire (Model 181-Turntable)

Is the air pressure within the recommended range?

Select the type of bearings to lubricate

Ensure equipment is locked off before lubrication

Clean grease zerk fittings before lubrication

Was excess lube wiped from the shaft seals?

Support the turntable while lifting

Bearing Removal and Replacement

Mount replacement parts properly

Recheck replacement parts after one day of use

Ensure the table or drive is not overloaded

Check and adjust belting take up tension

Track the belting at both ends of the conveyor

Check the belt splice for any damage

Is the reducer vent plug clear and operating?

Enter the current oil level at the level plug

Is the oil level at the bottom of the threaded hole of the level plug?

Is extra oil required due to conveyor and reducer inclination?

Clean the area around the reducer

Verify if the gearmotor requires lubricant change

Select the ambient temperature range

Select the lubricant based on the ambient temperature

Drain the old lubricant from the reducer

Refill the reducer with the selected lubricant

Check for any leaks after refilling

Dispose of the old lubricant according to environmental regulations