New London Engineering Conveyor 321

Check if the gearmotor requires lubricant change

Select the ambient temperature range

Select the manufacturer's recommended lubricant for 15 – 60°F

Select the manufacturer's recommended lubricant for 50-125°F

Drain the old lubricant from the reducer

Refill the reducer with the selected lubricant

Verify the lubricant level is correct

Dispose of the old lubricant according to environmental regulations

Loosen the table bearing set screws

Replace the caster with a New London Engineering replacement part

Retighten the setscrews after the table is lowered

Lock off equipment before maintenance

Ensure all movable equipment is stationary

Retighten setscrews and drive mounts

Check drives tire air pressure (Model 181-Turntable)

Are the bearings permanently lubricated?

Clean grease zerk fittings before lubrication

Wipe excess lube from shaft seals

Were bearing set screws tightened?

Support the turntable while lifting

Mount replacement parts properly

Recheck replacement parts after one day of use

Ensure the table or drive is not overloaded