Mack Vehicle TerraPro

DANGER: Tires used on multipiece rims must be assembled and inflated only by experienced, qualified personnel.

DANGER: NEVER position your body in front of the rim during inflation.

CAUTION: NEVER use water-based sealants, puncture proofing, or liquid balance materials containing water in All-Steel Radial Ply truck tires.

Inspect your tires daily. Look for bulges, cracks, cuts, penetrations and/or oil contamination.

Refer to the Maintenance and Lubrication Manual (21394653) for more information.

CAUTION: Never bleed air from your tires in an attempt to gain traction for a vehicle stuck in snow, ice or mud.

Check tire inflation pressure daily when the tires are cold (i.e., before the vehicle is driven).

Sign off on the daily tire inspection

Warning: Measurement of the oil level must be taken on level ground.

Best time to check oil level is while the engine is COLD or after the vehicle has sat approximately 2 hours.

CAUTION: Failure to wait a sufficient amount of time will result in an inaccurate dipstick reading.

The level must be close to the FULL line on the dipstick, but must NOT exceed the FULL line.

Is the vehicle on level ground?

Is the engine cold or has the vehicle sat for approximately 2 hours?

Enter the engine oil temperature

Is the oil level close to the FULL line on the dipstick?

Sign off on the daily engine oil level check

Recommendations for the first 30 days.

Wash the vehicle by hand with cool water, a mild car wash solution and a soft cloth or sponge.

Wash the vehicle in the shade, never in direct sunlight.

Do not dry wipe the finish; always use clean water.

Do not park near factories with heavy smoke fallout for extended periods of time.

Bird droppings have high acid content and can damage freshly painted surfaces. They should be cleaned off as soon as possible.

Do not spill gasoline, diesel fuel, oil, antifreeze, transmission fluid or any solvents of the like on the new finish. If you do. IMMEDIATELY rinse off with water. DO NOT WIPE.

Do not scrape ice or snow from surface. Brush off the loose material with a soft snow brush.

Sign off on the initial 30 days exterior washing

Warning: This procedure requires trained personnel with PPE!

Oil and hydraulic lines inspection

Upload a photo of the inspected areas

Additional notes on the inspection

CAUTION: Do not clean the underside of the fenders, cab, chassis, etc. without protecting your hands and arms. You may injure yourself on sharp-edged parts.

Soften the dirt on your cab with plenty of water and rinse.

Clean truck with a soft sponge/brush starting at the roof and working downward using slight pressure.

Rinse the sponge or brush often to keep it clean.

Clean wheels and dirtier areas with a separate sponge/brush.

Rinse truck thoroughly with water and wipe dry with a soft clean chamois or all cotton towels to avoid surface scratches and water spotting.

Sign off on the cab / hood maintenance