KSB SE & Co. KGaA High-Pressure In-Line Pump MOVITEC V(S)F 90B

Ensure work is performed by trained personnel

Take caution when working near rotating parts

Clean the lubricating nipples, if contaminated

Position the grease press on the lubricating nipple

Ensure only qualified personnel perform work on the pump set.

Verify the pump set has cooled down to ambient temperature.

Use suitable transport devices and lifting equipment for heavy components.

Observe all safety instructions and information.

Properly shut down the pump set.

Close the shut-off elements in suction and discharge line.

Drain the pump and release the pump pressure.

Vent the pump and suction line before starting up the pump set.

Prime the pump and suction line with the fluid to be handled.

Service the shaft seal regularly.

Check the condition of the lubricant regularly.

Check the rolling element bearings for running noises.

!CAUTION: Incorrect installation of mechanical seal. Damage to the machinery!

Ensure assembly/installation is carried out by qualified specialist personnel.

General Rules for Installing Mechanical Seal

Remove protective wrapping of contact faces immediately before installation.

Prevent any damage to sealing surfaces or O-rings.

Insert mechanical seal 433 and O-rings 412.01.

Fit the drive lantern and screw on nuts 920.03.

Wear safety clothing and a protective mask, if required.

Observe all legal regulations on the disposal of fluids posing a health hazard.

Collect and properly dispose of flushing fluid and any residues of the fluid handled.

Has the flushing fluid been disposed of according to legal regulations?

Has the pump set handled fluids whose residues could lead to corrosion or ignition?

Neutralise the pump set if necessary.