Daikin Air Conditioner Outdoor Unit RKC35QVMV

Waited for 10 minutes after turning off all power supplies?

Remove the screw of the stop valve cover

Pull down and remove the stop valve cover

Ensure the 3 hooks are fitted when reassembling

Remove the 3 screws, and then the top panel

Remove the 6 screws of the front panel

Lift up the right side of the front panel and unfasten the 2 hooks

Ensure all power supplies are turned off

Wait for 10 minutes after turning off power supplies before starting disassembly

Remove the 7 screws on the terminal board

Disconnect the connecting wire and power supply wire

Remove the 3 screws and the wire fixture

Disconnect the connector [S80] (four way valve coil)

Disconnect the connector [S20] (electronic expansion valve coil)

Warning: Wait for 10 minutes after turning off all power supplies before disassembling

Pull out the discharge pipe temperature thermistor

Ensure the fixture for the thermistor is not lost

Check for sound blanket (back) presence

Remove the sound blanket (back) if present

Pull out the outdoor heat exchanger thermistor

Ensure the clip for the thermistor is not lost

Wait for 10 minutes after turning off all power supplies before starting disassembly

Does the model have a ferrite core on the earth/ground harness?

Unfasten the hooks and remove the PCB

Ensure the projections are fitted to the PCB during reassembly

Warning: Wait for 10 minutes or more after turning off all power supplies before disassembling work

Remove the 2 screws of the reactor

Slide the reactor upward to unfasten the 2 hooks

Remove the 2 screws, and then the partition plate

Fit the hole on the partition plate to the hook on the bottom frame