Continental Tumble Dryer KT120S

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Check hoses for visible signs of deterioration

Is there any visible sign of deterioration on the hoses?

Replacement of Deteriorated Hoses

Replace any hose showing signs of deterioration immediately

Ensure all replaced hoses are properly installed

Ensure the following tools are available

Refer to Figure 13 for guidance

Remove screw plug from pressure tap

Connect a pressure gauge to the burner orifice pressure tap and record the pressure

Start tumble dryer and observe pressure once flame is burning

Adjust regulator screw to achieve the specified burner orifice pressure

Affix the appropriate country/gas category label over the main serial plate designations if required

Pressure Verification and Adjustment

Enter the current gas supply pressure

Is the gas supply pressure within the required range?

Adjust the gas supply pressure as necessary

Refer to Figure 12 for guidance during the procedure

Technician's signature to confirm completion

Ensure the dryer is used for drying water washed fabrics only.

Confirm that none of the following items are in the dryer

Ensure surrounding areas are free of flammable and combustible products.

Remove debris from the lint screen filter.

Clean inside of the lint filter compartment.

Clean the area around the exhaust opening and adjacent surrounding area from lint, dust, and dirt.