Continental Tumble Dryer KT120E

Inform the fire department about the upcoming maintenance test

Disconnect auxiliary output if it activates a building sprinkler

Verify the connection to the auxiliary output through the H-4 header connection

Check the relay rating (5 Amp, 250VAC max)

Did the auxiliary output activate during the test sequence?

Verify auxiliary output functions

Ensure the following tools are available

Refer to Figure 13 for guidance

Remove screw plug from pressure tap

Connect a U-tube manometer to the burner orifice pressure tap

Start tumble dryer and observe pressure once flame is burning

Ensure no open flames are present in the inspection area

Use non-corrosive leak detection fluid

Check all pipe connections for gas leaks

Was the inspection completed without any issues?

Describe any issues found during inspection

Affix appropriate country/gas category label if required

Gas Supply Pressure Verification

Enter the current gas supply pressure

Is the gas supply pressure within the normal range?

Manifold Pressure Verification and Adjustment

Enter the current manifold pressure

Is the manifold pressure within the normal range?

Adjust the gas valve governor/regulator as necessary

Affix the appropriate country/gas category label over the main serial plate designations if required.

Pressure Verification and Adjustment

Enter the current gas supply pressure.

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure if necessary.

Refer to Figure 12 for guidance.

Technician's signature to confirm completion of the procedure.