Continental Tumble Dryer KT120N

Ensure no open flames are present in the inspection area

Use non-corrosive leak detection fluid

Check all pipe connections for gas leaks

Was the inspection completed without any incidents?

Disconnect electric power to the tumble dryer before servicing.

Close gas shut-off valve to gas tumble dryer before servicing.

Close steam valve to steam tumble dryer before servicing.

Ensure all guards/panels are in place before starting the tumble dryer.

Reconnect any removed ground wires to ensure proper grounding of the tumble dryer.

Remove all lint from lint compartments and lint screen.

Affix appropriate country/gas category label if required

Gas Supply Pressure Verification

Enter the current gas supply pressure

Is the gas supply pressure within the normal range?

Manifold Pressure Verification and Adjustment

Enter the current manifold pressure

Is the manifold pressure within the normal range?

Adjust manifold pressure as necessary

Affix the appropriate country/gas category label over the main serial plate designations if required.

Pressure Verification and Adjustment

Measure the current gas supply pressure.

Is the gas supply pressure within the acceptable range?

Adjust the gas supply pressure if necessary.

Refer to Figure 12 for guidance during the procedure.

Technician's signature to confirm completion of the procedure.

Inform the fire department about the upcoming maintenance test

Is the auxiliary output connected to a building sprinkler system?

Disconnect auxiliary output if connected to a building sprinkler system

Activate the fire suppression system and check if the auxiliary output is triggered

Verify auxiliary output functions

Reconnect auxiliary output if it was disconnected