Conair Thermolator Temperature Control Unit CC-9kW-208V

Inspection of Cooling and Process Lines

Inspect the following for leaks

Were any leaks detected during inspection?

Stop the Thermolator if a leak is detected

Describe the location and nature of the leak

Inspection of Power Cords, Wires, and Electrical Connections

Inspect power cords, wires, and electrical connections for the following issues

Check exterior power cords for connection integrity

Check the ground wire and thermocouple connections

Replace any wire that appears damaged or has worn or cracked insulation

Unit and Surrounding Area Cleaning

Clean the unit and the area around it

Inspect air intake areas for obstructions

Remove any obstructions found in air intake areas

Is the floor around the unit dry?

Press any button to display the first test menu

Select the Calibration Mode menu

Apply the appropriate temperature to the control input using the thermocouple calibrator

Press the up ▲ key to begin calibrating

Wait until the control displays “don” or “bad”

Press Select to start the next calibration

Disconnect and lock out main power to the unit

Press any button to display the first test menu