Conair Carousel Plus Dryer MDCW100

Accessing the Regeneration Filter

Use a small flat screwdriver to gently pry down on the slot in the lower right hand corner of the filter grill while pulling out on the bottom.

Remove the filter from inside the grill.

Clean the filter with soap and water.

Replace the filter in the grill.

Turn off switch to stop conveying.

Disconnect the air and material hoses from the vacuum receiver.

Open the vacuum receiver lid by turning the latch counterclockwise and flipping the lid open.

Remove the mesh filter from the vacuum receiver.

Clean or replace the mesh filter if necessary.

Cleaning the Vacuum Receiver Body

Ensure you have the necessary equipment

Contact Conair Parts if necessary for equipment or parts

Standard Procedure for Models MDCW 15-100

Connect the portable dewpoint meter to the dewpoint check port of the dryer

Turn on the portable instrument and ensure positive airflow through the sensor

Monitor the readout and allow time for stabilization

Refer to the Troubleshooting section if dewpoint is not satisfactory

Inspection of Hoses and Gaskets

Inspect all hoses, clamps, fittings, and gaskets

Tighten any loose hose clamps or fittings

Replace worn or damaged hoses and gaskets

Turn off the conveying function

Remove the filter housing cover

Clean or replace the filter cartridge as necessary

Safety precautions for cleaning

Replace the filter cartridge and the filter housing cover