Baxter Infusion System 35700ABB

CAUTION: Static sensitive components

Perform procedure using proper anti-static techniques in an EOS/ESD safe work area

Disconnect the AC power adaptor and lay the pump on its front using a protective surface

Remove the screw located in the upper right hand corner of the wireless battery module

Depress the release mechanism and pull the module away from the back of the unit

Ensure fluid and air temperature is 72°F ±2°F

Verify IV set compatibility with the pump

Press the ON/OFF key to turn the unit on. Select any Care Area and Press OK.

Select any Drug Name and Press OK.

Press OK to select Primary Bag and Press OK to select mL/hr, then enter '4' and '6' using the keypad and observe the Rate mL/hr field to be '46'.

Press the CLEAR soft key and verify that the Rate mL/hr field is cleared to 0.

Enter '7', '8', and '9' using the keypad and observe the Rate mL/hr field to be '789'.

Is this a standalone test or following the Upstream (Proximal) Occlusion Sensor Test?

Turn the Pump ON if this is a standalone test.

Program and Options Configuration

Press the Clear Program soft key, confirm by pressing YES.

Press the OPTIONS soft key, select BioMed Options, and enter the password.

Select Sensor Configuration and press OK.

Press the EXIT soft key two times to return to the OPTIONS screen.

Disconnect the AC power adaptor and lay the pump on its front using a protective surface.

Remove the screw located in the upper right-hand corner of the SIGMA Spectrum battery (if equipped).

Depress the release mechanism found in the top center portion of the battery and pull away from the back of the unit.

Install the battery by placing the battery insulation tab over the terminals.

Gently slide the battery down the back of the case and insert the bottom of the battery into the pocket, then pivot it into the latch.

Press STOP then OFF and unplug the AC power adaptor before cleaning.

Ensure not to sterilize by autoclaving, ETO gas or spraying.

Avoid immersing any part of the pump.

Avoid using phenolic-based cleaners or disinfectants.

Do not use spray or aerosol cleaners.

Use alcohol in a well-ventilated area.

Prevent shorting of the battery pack’s exposed terminals during cleaning.