AXIS PTZ Network Camera P5515/-E

Use a non-abrasive, solvent-free neutral soap or detergent with water and a soft cloth

Rinse well with clean lukewarm water

Dry with a soft cloth to prevent water spotting

Refer to the device’s user manual for detailed instructions

Specify the location and type of loose screws

Tighten the loose screws according to the torque values in the device’s installation guide

Is the camera securely mounted after maintenance?

Verify the IP rating is maintained

Unplug the device from the power source

Clean the outer heat sink according to the instructions in the device’s installation guide

Inspect the heat sink for any visible damage

Plug the device back into the power source

Bracket Inspection and Cleaning

Inspect the bracket for insects and dirt

Remove insects and dirt from the bracket

Is the camera installed on an Axis bracket?

Install AXIS T91A6 Pipe Seal inside the bracket

Perform tasks on the camera’s webpage (live view)

Use the device with the following browsers

Go to Settings > System > Maintenance > Reports and click View the server report

Search for PTZCounter and note the value

Is the PTZ counter above the (x) value?

If camera functions normally, continue using while observing behavior