Viking Positive Displacement Pump L1124AE

Is there visible wear on the rotor teeth?

Refer to TSM for specific model series instructions and describe the procedure followed

Measure the current end clearance

Enter the desired end clearance value

Was the end clearance adjusted successfully?

Ensure pressure in the chamber is completely vented

Lock out or make non-operational the driving means

Identify the liquid the pump has been handling

Obtain and understand the material safety data sheet (MSDS) for the liquid

Loosen the two set screws in the outer face of the bearing housing

Rotate the bearing housing clockwise until it cannot be turned anymore

Mark the outside diameter of the bearing housing and the pump bracket

Did the idler slide off the idler pin during removal?

Is the idler bushing showing moderate wear?

Is the idler pin showing moderate wear?

Replace idler bushing if showing moderate wear

Replace idler pin if showing moderate wear

Ensure pump ports are square and in proper position

Shim or move the pump as required

Is piping forced to line up with the ports?

Flexible Coupling Alignment Check

Remove any coupling guards or covers

Check alignment of the coupling halves using a straightedge

Check alignment using a long straightedge or tightly drawn string across the face of the sheaves

Ensure pressure in the chamber is completely vented

Lock out or make non-operational the driving means

Obtain and understand the MSDS for the liquid handled by the pump

Mark head and casing before disassembly

Remove nuts and capscrews from head

Use jack bolts to back head away from casing

Tilt top of head back when removing to prevent idler from falling