United Metal Products Evaporative Cooler UMP-939 D

Ensure the following conditions are met before lubrication

Lubricate the bearings with NLGI No. 2 or 3 multipurpose ball bearing grease

Was the shaft rotated monthly during storage?

Is there any sign of over greasing?

Ensure the area is clean after lubrication

SAFETY NOTE: GUARDS MUST BE INSTALLED WHEN THE ROTATING FAN PROP OR WHEEL IS OPERATING ABOVE AN OCCUPIED SPACE OR WITHIN 7FT OF WORKING AREA OR WHENEVER DEEMED ADVISABLE FOR SAFETY REASONS.

Place the motor on the adjustable motor base - either pivot plate or manual slide rail.

Adjust motor as required to assure proper belt tension.

Describe any issues encountered during the assembly process

Disconnect power before servicing pump

Snap the plastic grid off the bottom of the pump

Remove old debris from the reservoir

Coat painted galvanized steel reservoirs with high quality sub-sealer

Remove pad frame from cabinet by lifting from the bottom edge and pulling outward, then letting it drop.

Is it necessary to wash dirt and scale from pad frame with a mild detergent?

Guards must be installed when the rotating fan prop or wheel is operating above an occupied space or within 7ft of working area or whenever deemed advisable for safety reasons.

Install the sheave, pulley, and belt before setting the unit over the roof opening.

Place the motor on the flat side of the adjustable motor base so that the drive belt will pass through the oblong cut out.

Adjust motor base as required to assure proper belt tension.