Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.

Documents & Manuals

Find all the essential guides in one place.

Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more

Work Order Templates

Pre-built workflows to keep your asset running smoothly.

Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more

Procedures

Integrate maintenance plans directly into your work orders.

Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more

Parts

Access the parts list for your equipment in MaintainX.

Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Toyota Steer Loader 4SDK3

Create an account to install this asset package.

Maintenance Plans for Toyota Steer Loader Model 4SDK3

Integrate maintenance plans directly into your work orders in MaintainX.

1000 Hourly / 6 Monthly Steer Loader Maintenance

Fuel system injection timing measurement, correction, adjustment

Fuel filter replacement

Fuel filter element replacement

Reduction device oil replacement

Pre-heater glow plug heat coil brackage inspection, correction and replacement (as required)

Pre-heater intake heater inspection, correction and replacement (as required)

Battery specific gravity measurement, correction, adjustment

Sign off on the maintenance procedure

Run this procedure

170 Hourly / 1 Monthly Steer Loader Adjustemnt

ENGINE:

1) Basic components:

- Rotating condition during idling

- Rotating condition during acceleration

2) Governor:

Maximum no-load stabilized rotation speed

RUNNING EQUIPMENT:

1) Wheels:

- Tire air pressure

Run this procedure

170 Hourly / 1 Monthly Steer Loader Inspection

ENGINE:

1) Basic Components:

- Starting condition and unusual noise

- Exhaust condition

2) Lubrication system:

- Oil leakage

- Oil level

- Clogging and fouling of oil filter

3) Fuel system:

Run this procedure

170 Hourly / 1 Monthly Steer Loader Maintenance

Engine oil replaced

Engine oil filter replaced

Air cleaner element cleaned

Wheels loose hub bolts and hub nuts tightened

Hydraulic cylinder: cylinder installed portion tightened if loose

Operator guard and side guard tightened if loose

Each part greased up

Sign off on the steer loader maintenance

Run this procedure

1 Weekly Air Cleaner Cleaning

Clean the air cleaner as soon as needed.

Remove the air cleaner dust-cap, remove the wing nut which holds on the element, and take out the element.

● Cleaning the element:

For normal cleaning, blow out the air cleaner from inside the element with compressed air (7-kgf/cm² (99 psi) or less), or tap it lightly and knock out the dust.

If the element is extremely dirty, it can also be washed. Replace the element after 6 washings or 1 year.

● Washing the element:

Dissolve a neutral cleaning agent in warm (about 40°C) water, soak the element in this cleaning solution for 15 or 20 minutes, and then wash it. Check to see that the filter paper has not become torn.

After washing the element, rinse it well in clean water.

Dry it off by letting it dry by itself or by using a cold-air dryer. Never dry the element with compressed air or fire.

Run this procedure