

Turn manuals into instant answers
with your AI-powered assistantTurn manuals into instant answers
with your AI-powered assistant
Get instant access to all the maintenance information you need. Empower technicians to perform preventive maintenance with asset packages, ready to use right out of the box.
Find all the essential guides in one place.
Tensioning Guide
Belt-diagram
C-120 pulleys
+ 13 more
Pre-built workflows to keep your asset running smoothly.
Daily Electrical System Inspection
Replace Roller and Pulley
Install Engine B-120
+ 29 more
Integrate maintenance plans directly into your work orders.
Motion Industries
Applied Industrial Technologies
Electrical Brothers
+ 5 more
Access the parts list for your equipment in MaintainX.
Drive Motor
B2 Rollers
Tensioning System
+ 40 more

Toyota Vehicle Tacoma
Create an account to install this asset package.
Integrate maintenance plans directly into your work orders in MaintainX.
2 Weekly Tire Inflation Pressure Check
Warning: Incorrect tire inflation pressure may result in reduced fuel economy, reduced driving comfort and poor handling, reduced tire life due to wear, reduced safety, and damage to the drive train.
If a tire needs frequent inflating, have it checked by your Toyota dealer.
When checking tire inflation pressure, observe the following: Check only when the tires are cold. Always use a tire pressure gauge. It is normal for the tire inflation pressure to be higher after driving as heat is generated in the tire. Do not reduce tire inflation pressure after driving. Never exceed the vehicle capacity weight. Passengers and luggage weight should be placed so that the vehicle is balanced.
WARNING: Keep your tires properly inflated. If the tires are not properly inflated, the following conditions may occur which could lead to an accident resulting in death or serious injury: Excessive wear, Uneven wear, Poor handling, Possibility of blowouts resulting from overheated tires, Air leaking from between tire and wheel, Wheel deformation and/or tire damage, Greater possibility of tire damage while driving (due to road hazards, expansion joints, sharp edges in the road, etc.)
NOTICE: Be sure to put the tire valve caps back on. If a valve cap is not installed, dirt or moisture may get into the valve and cause an air leak, resulting in decreased tire inflation pressure.
Enter the cold tire inflation pressure reading
Is the tire inflation pressure at the recommended level?
Did you adjust the pressure if it was not at the recommended level?
Did you deflate the tire if you added too much air?
6 Monthly Vehicle Interior Cleaning
Protecting the vehicle interior
Remove dirt and dust using a vacuum cleaner
Wipe dirty surfaces with a cloth dampened with lukewarm water
If dirt cannot be removed, wipe it off with a soft cloth dampened with neutral detergent diluted to approximately 1%
Cleaning the leather areas
Remove dirt and dust using a vacuum cleaner
Wipe off any excess dirt and dust with a soft cloth dampened with diluted detergent
Wipe the surface with a dry, soft cloth to remove any remaining moisture. Allow the leather to dry in a shaded and ventilated area
Cleaning the synthetic leather areas
Air Conditioning Filter Replacement
Removal Method
Engine switched off
Glove box opened
Cover removed by sliding up and pulling toward you
Filter cover removed
Filter pulled out of the filter outlet
Replacement Method
Old air conditioning filter removed
New filter installed following the instructions on the label
Battery Maintenance
Warning: Battery maintenance requires trained personnel with PPE!
Battery exterior check
Battery terminals check
Hold-down clamp check
Before recharging
Is the ground cable disconnected?
Is the power switch on the charger off?
After recharging/reconnecting the battery (vehicles with a smart key system)
Engine start check
Brake Fluid Check
Warning: Brake fluid can harm your hands and eyes and damage painted surfaces. If fluid gets on your hands or in your eyes, flush the affected area with clean water immediately.
Is the brake fluid level between the “MAX” and “MIN” lines on the tank?
If the fluid level is low or high, it is normal for the brake fluid level to go down slightly as the brake pads wear out or when the fluid level in the accumulator is high.
If the reservoir needs frequent refilling, there may be a serious problem.
Select the fluid type used
Is the funnel clean?
Turn the engine off.
Depress the brake pedal 20 times or more.
Remove the reservoir cap.
MaintainX CoPilot is your expert colleague, on call 24/7, helping your team find the answers they need to keep equipment running.
Reduce Unplanned Downtime
Ensure your team follows consistent procedures to minimize equipment failures and costly delays.
Maximize Asset Availability
Keep your assets running longer and more reliably, with standardized maintenance workflows from OEM manuals.
Lower Maintenance Costs
Turn any technician into an expert to streamline operations, maintain more assets, and reduce overall costs.
Thousands of companies manage their assets with MaintainX













