Toyota Vehicle 4 RUNNER

Warning: Incorrect tire inflation pressure may result in reduced fuel efficiency, reduced driving comfort and tire life, reduced safety, and damage to the drive train.

CAUTION: Keep your tires properly inflated. Otherwise, conditions such as excessive wear, uneven wear, poor handling, possibility of blowouts resulting from overheated tires, poor sealing of the tire bead, wheel deformation and/or tire separation, and a greater possibility of tire damage from road hazards may occur.

NOTICE: Be sure to put the tire valve caps back on. Without the valve caps, dirt or moisture could get into the valve and cause air leakage, which could result in an accident.

Tire inflation pressure at the recommended level

No leakage after applying soapy water to the valve

Tire inflation pressure checked when tires are cold

The air conditioning filter must be cleaned or changed regularly to maintain air conditioning efficiency.

Turn the engine switch (vehicles without a smart key system) or “ENGINE START STOP” switch (vehicles with a smart key system) off.

Open the glove box and remove the cover.

The “↑UP” marks shown on the filter should be pointing up.

If the filter is dirty, clean by blowing compressed air through the filter from the underside.

No loose connections, cracks, or loose clamps

Before recharging, observe the following:

Is the ground cable disconnected?

Is the power switch on the charger off when connecting and disconnecting the charger cables to the battery?

After recharging/reconnecting the battery (vehicles with smart key system)

Can the doors be unlocked using the smart key system?

Can the engine start with the “ENGINE START STOP” switch in ACCESSORY mode?

Is the “ENGINE START STOP” switch mode recorded by the vehicle?

The brake fluid level should be between the “MAX” and “MIN” lines on the tank.

Make sure to check the fluid type and prepare the necessary item.

Vehicles without a smart key system Turn the engine switch off.

Vehicles with a smart key system

Turn the “ENGINE START STOP” switch off.

Depress the brake pedal more than 40 times.

Replace the battery with a new one if it is depleted.

You will need the following items:

Lithium battery CR2016 (vehicles without a smart key system), or CR1632 (vehicles with a smart key system)

Replacing the battery (vehicles without a smart key system)

To prevent damage to the key, cover the tip of the screwdriver with a rag.

Open the case cover using a coin protected with tape etc. and remove the depleted battery.