Intertape Polymer Group Case Sealer USC2020TB

Hardware: Re-Tighten any Loose Hardware

Plastic Guide Rollers: Check for free spinning. Disassemble and remove any adhesive build up

Knurled Teflon Coated One Direction Clutch Roller: Back off tension. Check for free spinning. Disassemble and remove any adhesive build up

Knurled Teflon Coated Guide Roller: Rotation should be slightly restricted by Belville washer. Disassemble and remove any adhesive build up if excessive restriction is detected

Front Red Wipe Down Rollers: Rotation should be slightly restricted by Belville washer. Disassemble and remove any adhesive build up if excessive restriction is detected

Rear Red Wipe Down Rollers: Check for free spinning. Disassemble and remove any adhesive build up

Carton Dust In/On Machine: Blow Off Machine Extenally and Internally

Carton Dust Inside Drive Bases: Remove Drive Base Cover

Blade Guard Oiler Pad: Lubricate

Hardware: Re-tighten any loose hardware

Hardware: Replace any missing hardware

Mandrel Assembly: Disassemble & Observe

Mandrel Spring: Check for weakness

Mandrel Shaft: Remove any dust and adhesive build up

Mandrel Bearing: Check for wear

Delrin Roller: Check for free spinning. Disassemble and remove any adhesive build up

Warning: This procedure requires trained personnel with appropriate tools!

Upper head assembly loose and moves excessively?

If not, report the issue to the maintenance team and stop the procedure

Upload a photo of the removed screws

Upper column guide bolts adjusted to reduce clearance?

Enter the clearance between column and guide for upper column

Both upper column guides adjusted equally?

Each column adjusted equally for upper column guides?

Warning: This procedure requires trained personnel with PPE!

Remove screws (2) and drive base cover using a 3 mm Allen key

Tighten upper and lower belt tensioning bolts using a 4 mm Allen key and 10 mm wrench

Adjust upper and lower tensioning bolts equally

Achieve proper belt tension when a 5 pound pull force is used to create a 1” gap in the middle of the drive base

Ensure the belt is properly tracked in idler pulley and the tracking bead is properly centered in the idler pulley groove

Adjust upper and lower tensioning bolts as required to align tracking bead with the center of groove in the idler pulley

Replace drive base cover as shown using a 3 mm Allen key

Sign off on the drive belt adjustment