Frick Rotary Screw Compressor RWF II 100

Check the compressor unit daily for leaks

Log any issues found during the check

Sign off on the daily compressor unit check

Warning: This procedure requires trained personnel with PPE!

EZ-CAL High pressure cut-out check valve test block

Is the EZ-CAL test block installed on the package?

Is the pressure transducer wired to the Quantum HD controller?

Is the tubing run to the compressor discharge connection?

Is the HPCO fully open to the discharge pressure source in the RUN position?

Is the external source connected directly to the HPCO in the TEST position?

Is the function of the HPCO and pressure setting confirmed by application of external pressure?

WARNING: Failure to enter skip frequencies could cause catastrophic compressor failure or severe compressor damage and result in serious injury or death.

Check for excess vibration and skip frequencies anytime unit operating conditions change

Decrease the VFD speed by 100 rpm increments and check for elevated energy

Check for elevated energy at the decreased speed

Enter the vibration meter reading

Does the vibration meter reading meet or exceed one inch per second?

If yes, set the frequency range to be skipped in the microprocessor for the VFD

Warning: Use of filter elements other than Frick may cause warranty claim to be denied.

Is a single oil filter installed?

If a single oil filter is installed, push [STOP] key on microprocessor panel to shut down unit, then open disconnect switches for compressor and oil pump motor starters.

If dual oil filters are installed, open the outlet, then inlet service valves of the standby filter.

Warning: Open inlet service valve slowly to prevent a sudden pressure drop which could cause an oil filter differential alarm.

Did you close outlet then inlet service valves of filter being serviced?

Did you open bleed valve and purge pressure from the oil filter cartridge?

Notice: Recover or transfer all refrigerant vapor, in accordance with local ordinances, before opening to atmosphere.

Did you remove the plug from the bottom of the filter canister and drain the oil?

Check coupling: Check bolts, shim packs, center inserts, keys, and all bolt torques.

Check alignment: Refer to 070.210-IB for foot mounting alignment.

Suction and discharge flange bolts: Verify tightness of bolts on suction and discharge flanges. See Table 13 for torque requirements.

Check electrical connections: Check and torque all terminals in the processor and starter panel per the specification posted in the enclosure.

Check sensor calibration: Check calibration of slide valve, slide stop, pressures and temperatures. Calibration should be conducted with NIST certified devices.

Sign off on the 200 Hourly Rotary Screw Compressor Check