Novexx Solutions Label Printer XLP 506

Switch off the device and disconnect the mains power connecting line

Ensure no liquid gets into the machine

Avoid using spray bottles or sprays on the machine

Ensure repairs are only made by trained service technicians

Avoid using sharp cleaning materials

Do not use cleaning agents that could damage the machine's components

Ensure the print head has cooled down before cleaning

Switch off the device and disconnect the mains power connecting line.

Ensure no liquid enters the machine.

Avoid using spray bottles or sprays directly on the machine.

Repairs must only be made by trained service technicians.

Avoid using sharp cleaning materials that may damage the printer.

Do not use cleaning agents that could damage the paint finish, labelling, display, type plates, or electrical components.

Avoid scouring cleaning agents or those that could dissolve plastic.

Switch off the device and disconnect the power cable

Ensure no liquid enters the machine

Ensure repairs are conducted by trained technicians only

Ensure the print head has cooled down before cleaning

Switch off the printer and disconnect from the power

Remove material and ribbon from the printer

Switch off the device before cleaning or maintenance and pull out the mains power connecting line!

Ensure no liquid gets into the machine

Avoid using spray bottles or sprays directly on the machine

Repairs must only be made by trained service technicians

Do not use cleaning agents or materials that could damage the paint finish, labelling, display, type plates, or electrical components

Avoid scouring cleaning agents or those that could dissolve plastic

Do not use acid or alkaline solutions

Ensure all necessary tools are available

Tighten the set screw [104A] in the material guide to increase the driving force

Check the movability of the material guide. If necessary, repeat tightening the set screw [104A]

Adjust the friction according to the factory settings: see service manual