Labconco Biosafety Cabinets 30241xxx2

Confirm if the UV lamp is present in the model

Safety and Disposal Instructions

Ensure compliance with local disposal laws for hazardous waste

Consult www.lamprecycle.org for safe handling, recycling, and disposal information

Record the UV lamp hour meter reading

Start the cabinet blower and let it operate for 5 minutes

Raise the sash to its full open position

Ensure all electrical power has been removed by disconnecting the main electrical connection.

Remove the dress panel as noted in Figure 8-4.

Locate and remove the Left End Cap by pulling it away from the lamp ends.

Remove both Socket Caps by pulling each straight off the right end of the lamp one at a time.

Pull each LED Lamp straight toward you to release it from the Spring Clips.

Note the rotational position of the old LED lamps for correct orientation of new lamps.

Disinfect interior surfaces with suitable chemical disinfectant

Wipe down interior surfaces with 70% alcohol solution after contact time elapsed

Wipe down the interior surfaces of the cabinet with a suitable disinfectant or 70% ethanol and allow to dry

Periodically lift the work surface and wipe down the area beneath it

Inspect and clean the towel catch located at the rear of the work area, beneath the work surface

Dispose of rubber gloves appropriately

Lift the front edge of the work surface by grasping the knob at either front corner

Is removal of the work surface necessary?

Reinstall the dished work surface by resting the bottom on the center support and pushing it back into the cabinet

Engage the tabs on the back corners of the work surface with the slots on the rear wall of the work area

Pull the work surface straight out, letting the rear edge rest on the center support underneath

Perform the following tests as per NSF/ANSI Standard Number 49

Perform user comfort related tests if necessary

Was the cabinet recertified by a qualified technician?

Notes or observations during certification